R
Rabble
My default settings for Sounds and Audio Properties do not work.
If I go to Hardware Properties, My Soundmax Audio is indicated as "Enabled"
but, in reality it is not and I have to disable it then "Enable' it again to
get Audio to work.
My Volume Properties in S and A shows "No Audio Device" and no Volume
Control is available in the Task Bar until I do the reset.
The Audio shows a default of "Modem#3 Line Playback". The same for Record.
No MIDI device shown.
This happens every time that I close down.
I have reinstalled SoundMax - any ideas on this problem please
TIA
Ron
If I go to Hardware Properties, My Soundmax Audio is indicated as "Enabled"
but, in reality it is not and I have to disable it then "Enable' it again to
get Audio to work.
My Volume Properties in S and A shows "No Audio Device" and no Volume
Control is available in the Task Bar until I do the reset.
The Audio shows a default of "Modem#3 Line Playback". The same for Record.
No MIDI device shown.
This happens every time that I close down.
I have reinstalled SoundMax - any ideas on this problem please
TIA
Ron