RE: Can't Stop the Error Messages!!!

  • Thread starter Thread starter RLBobH
  • Start date Start date
R

RLBobH

I, too, keep getting an error message pop up that I cannot get rid of. It is
"PrintServer connect fail". I run XP, and got this message when I had not
started my remote printer. Afterwards, I started the printer, printed many
messages, but continur to get this pop-up.

Any thoughts?

"Shawnlevy" wrote:

> Installed SP2 last week and since then have been bombared with little Error
> Message windows.
>
> There were a few settings that needed adjusting, which I've seen to.
>
> Now, I still get 'em in waves of 20 or 30 each time.
>
> And there is no record of a problem in eventvwr.msc.
>
> Any ideas/hints?
>
> Desperately,
>
> Shawn
 
> I, too, keep getting an error message pop up that I cannot get rid
> of. It is "PrintServer connect fail". I run XP, and got this
> message when I had not started my remote printer. Afterwards, I
> started the printer, printed many messages, but continur to get this
> pop-up.
>
> Any thoughts?


Well, uhhh, when the printer is turned off and the software tries to
connect to it and can't, well, uhhhh, that's sort of a "connect FAIL",
is it not? Then when you turned the printer ON, it finally made its
connection.
To get rid of the error, try ... START THE PRINTER!?!?!?!

You are also in bad need of reading this URL:
http://en.wikipedia.org/wiki/Thread_hijacking



>
> "Shawnlevy" wrote:
>
>> Installed SP2 last week and since then have been bombared with
>> little Error Message windows.
>>
>> There were a few settings that needed adjusting, which I've seen to.
>>
>> Now, I still get 'em in waves of 20 or 30 each time.
>>
>> And there is no record of a problem in eventvwr.msc.
>>
>> Any ideas/hints?
>>
>> Desperately,
>>
>> Shawn
 
Back
Top