Windows NT Possible to change network ports used by terminal services licensi

  • Thread starter Thread starter Aidan-Eire
  • Start date Start date
A

Aidan-Eire

Hi,

I have a bit of a dilemma. Due to firewalls between terminal server and
licensing server I need to open up ports to allow this traffic. Howerver our
security policy won't allow this as required ports are too unsecure... port
135 445 and 1025-65000,. Can anybody please tell me if there is a way yo
change these ports and ideally tie down all the traffic to one assigned port??



Thanks for any replies!,

Aidan.
 
I think the TS uses DCOM when talking to it's licensing server.
Unfortunately DCOM communications between two servers cannot (read:
should not) be restricted to one single port. Use a small port range
instead. Additionally you always need port 135 (TCP I think).

The following article from the Microsoft KB explains how to configure
this:

http://support.microsoft.com/?scid=kb;en-us;300083&x=11&y=14

I hope this helps.

Helge

==================
Please visit my blog:
http://it-from-inside.blogspot.com
==================

On 7 Aug., 18:18, Aidan-Eire <AidanE...@discussions.microsoft.com>
wrote:
> Hi,
>
> I have a bit of a dilemma. Due to firewalls between terminal server and
> licensing server I need to open up ports to allow this traffic. Howerver our
> security policy won't allow this as required ports are too unsecure... port
> 135 445 and 1025-65000,. Can anybody please tell me if there is a way yo
> change these ports and ideally tie down all the traffic to one assigned port??
>
> Thanks for any replies!,
>
> Aidan.
 
Back
Top