N
no1_vern
Before installing the SP3, I had my Dell 2005FPW monitor rotated 90 degrees to that it was oriented up and down (easier reading).
After installing SP3 RC, I found out that the orientation of my monitor had reverted to the 0 degrees aspect. I have removed and reinstalled the ATI Catalyst Control Center(CCC) monitor suite, updated the driver, and then removed and updated both a second time in an attempt to correct this problem. I cannot change it back to the 90 degrees aspect I want. When I go into the Ati CCC, I can hear the hard drives read/write but display will not change.
My configuration is:
Ati x800-XT/256m,
Dell 2005FPW (Digital)
Dell XPS 3.46 pentium,
1 gig Memory,
150G SATA (2 150G drives in raid-1),
NEC DVD-r/rw9ND-3450A)
Samsung CD-R/RW(SW-252S)
WinXP Home Edition
I believe this is a settings error, but other than that I really cant tell what is going on. Any info would be really appreciated!
Vern
Continue reading...
After installing SP3 RC, I found out that the orientation of my monitor had reverted to the 0 degrees aspect. I have removed and reinstalled the ATI Catalyst Control Center(CCC) monitor suite, updated the driver, and then removed and updated both a second time in an attempt to correct this problem. I cannot change it back to the 90 degrees aspect I want. When I go into the Ati CCC, I can hear the hard drives read/write but display will not change.
My configuration is:
Ati x800-XT/256m,
Dell 2005FPW (Digital)
Dell XPS 3.46 pentium,
1 gig Memory,
150G SATA (2 150G drives in raid-1),
NEC DVD-r/rw9ND-3450A)
Samsung CD-R/RW(SW-252S)
WinXP Home Edition
I believe this is a settings error, but other than that I really cant tell what is going on. Any info would be really appreciated!
Vern
Continue reading...