Windows 2000 IBM Serveraid 4xl Error

  • Thread starter Thread starter Thom
  • Start date Start date
T

Thom

I am installing windows 2000 on a IBM eserver with a IBM Serveraid 4xl card
for the storage system. When I start the install I press F6 that will allow
me to specify a specific driver. I insert the floppy when asked and it
detects the proper driver. I select the driver and then let install proceed.
After a bit it give an error that nfrd960.sys was not found and setup fails.
The nfrd960 file is on the floppy so I can not figure out what is happening.

Any ideas would be appreciated, the other option is to install Windows2003
but I can not get the CD drive to read my disk so I was going to attempt an
upgrade to get to 2003, that is the reason for the 2000 install.
 
You might try recreating the driver disk. Also make sure the driver version
is compatible with the firmware version.

http://www-304.ibm.com/systems/support/supportsite.wss/docdisplay?lndocid=SERV-RAID&brandind=5000008

http://www-304.ibm.com/systems/supp...cdisplay?lndocid=MIGR-4QDMES&brandind=5000008



--

Regards,

Dave Patrick ....Please no email replies - reply in newsgroup.
Microsoft Certified Professional
Microsoft MVP [Windows]
http://www.microsoft.com/protect

"Thom" wrote:
>I am installing windows 2000 on a IBM eserver with a IBM Serveraid 4xl card
> for the storage system. When I start the install I press F6 that will
> allow
> me to specify a specific driver. I insert the floppy when asked and it
> detects the proper driver. I select the driver and then let install
> proceed.
> After a bit it give an error that nfrd960.sys was not found and setup
> fails.
> The nfrd960 file is on the floppy so I can not figure out what is
> happening.
>
> Any ideas would be appreciated, the other option is to install Windows2003
> but I can not get the CD drive to read my disk so I was going to attempt
> an
> upgrade to get to 2003, that is the reason for the 2000 install.
 
Back
Top